I have turned in my notice at work. I’ve told you in these pages that I’m doing it again. That requires tuning up – both me and the bike. Four years ago I wrote about training. I won’t do it again. Write about it, that is. Doing it – training – is even more imperative when 70 is right around the corner.
In one of those “If You Give a Pig a Pancake” moments, I decided to replace my cables for the coast-to-coast trip. I figured I’d do those before the season, since there could be some stretching and adjustment needed. I’d replace the chain closer to the ride date, and mount fresh tires for the trip. So it was in March that the bike first went up on the stand…
When I put the bike up on the stand, I realized it was dirty. No sense putting clean parts on a dirty bike, so cleaning comes first. If you’re going to clean anyway, you might as well take off some parts to get at the dirt…
One of the more fun aspects of owning a bike with internally-routed cables is actually routing those cables. If you’ve ever tried it, you know I’m being facetious. Park Tools makes a kit for the job. Unfortunately, their expensive tool does not work on some bikes. One of their options is a plastic sleeve that goes over the cable end and attaches to a guide. Another is a thin cable with a magnet on the end to thread through the tube and attract your cable end. The problem there is that the opening at the end of my chain stay is smaller than Park’s guide and magnet. A third option is a magnet to run along the outside of your tubing to attract and guide the cable. The problem there is that high quality cables are stainless steel and therefore not magnetic. What to do?
I fabricated a series of tools from old spokes that accomplish these and other tasks.
Trying to route cables using your old housing but you don’t want to redo your bar tape and the cable won’t go? The tool at the top will do the trick.
Trying to route through the tiny hole at the back of the chain stay? Superglue and thread.
Leave the old cable in place and cut it at the bottom bracket. Remove the top half. Thread the new cable to the bottom bracket. You might need the tool above to get it under the bar tape. Go to the bottom bracket where you now have both cables. Put a drop of Superglue on the end of the old cable. Spread the glue a bit. Wrap thread tightly around the end of the cable. Let it dry. Place cables end-to-end, put a drop of Superglue on the end of the new cable, wrap thread tightly, let it dry. Now go to the exit hole at the back end of the chainstay. You will use the old cable to guide the new one through the chainstay. Gently pull the old cable through, guiding the new cable into the chainstay at the bottom bracket. Keep pulling (and gently feeding the new cable) until both come through. You should have enough cable that you can cut above the Superglue before threading into your derailleur.
Rear brake cable travels along the top tube with no problem, but now you can’t get the end out? Try the hooks.
No patents on these tools. No cost beyond some old spokes and time with a file and pliers. Feel free to make some and try it yourself! The tools you need may vary with your bike. If you have a few old spokes, play around until you make the tool you need.